Steps to move a upright piano

Pianos consistently make movers yearly list of products that are most often damaged. Grand pianos are particularly troublesome. Practicing the following procedures for disassembling, padding and filling grand pianos will avoid damage, lower claims cost, and improve consumer fulfillment.

1) A minimum of three people are required to deal with an infant grand piano. If the infant grand piano needs to increase or down stairs or if a full or concert grand piano requires to be carried, a minimum of 4 people are needed.

2) Constantly complete a precise and thorough stock. It may be essential or more suitable to use a visual stock to adequately explain and reveal pre-existing damage.

3) As various parts are taken apart, please location all hardware in a properly labeled parts bag and then position the parts bag in a "Parts Box".

4) Get rid of the music rack (lyre) from its track by pulling it toward the keyboard. Wrap it in a tidy furnishings pad.

5) Detach the cover by getting rid of the hinge pins. Wrap the cover in a tidy furnishings pad.

6) Eliminate the prop that holds the cover open and cover it in a tidy furnishings pad. The prop has a hinge pin and remains in 2 pieces.

7) Get rid of the pedal assembly and cover it in a clean furnishings pad. When getting rid of the screws, please be cautious not to drop the braces. As you deal with the piano, number the push-rods from left to right as "1", "2", and "3", by positioning a piece of masking tape with the suitable number on each rod.

8) Pad the piano by positioning a tidy rolled furniture pad (stretch-wrap the pad to avoid it from unrolling) on the cover of the keyboard to avoid it from flopping open while you deal with the piano. Keep in mind: Please guarantee that the surface area of the piano is dust-free prior to padding it.

9) Position a piano board and attach the straps so that it is prepared to get the piano. The raised brace on the piano board should be at the keyboard end of the piano.

10) Eliminate the left front leg by placing someone below the piano at the left end of the keyboard. The other two people must support the left front corner. The individual below the piano need to turn the retaining block so that the long end points far from the leg. The screws, if there are any, need to then be gotten rid of. The "below" individual needs to then extricate the piano prior to actually removing the leg. Be read this article sure to have 2 individuals raising the corner of the piano while the 3rd person gets rid of the leg. Note: Please be sure to keep in mind which legs were gotten rid of from which positions given that some pianos have legs that are not interchangeable.

11) Location the piano on the piano board by decreasing the "leg-less" end onto the click here board. Please be sure to lift the entire piano somewhat while finishing this maneuver to avoid undue pressure on the remaining, connected legs as the piano pointers. Be sure that the piano is focused comfortably versus the brace at the end of the piano board.

12) Remove the two remaining legs and cover them in tidy furnishings pads. These legs are kept in location by a "key and slot" arrangement. To get rid of the leg, slide it inward towards the center of the piano till it comes out of the slot.

13) Protect the piano to the piano board by bringing the ends of the straps together and attaching them. Location folded burlap pads over the furniture pads but under the straps to provide additional protection to the edges of the piano. To prevent the strap near the narrow end of the piano from slipping off, tie the loose ends of the two straps together.

14) To move the piano over a flat, level surface, tilt the piano and piano board and place a four-wheel dolly under the center of the piano board.

15) To move the piano up or down stairs, utilize the piano board as a skid. After adequately padding the stairs for security against residence damage, position the keyboard end of the piano towards the bottom of the stairs. Connect a bulge strap to the look at this site leading end of the piano board to avoid the piano from slipping.

16) To fill the piano, leave it on the piano board and location it in a tier as the very first base product with the keyboard facing the wall of the preceding tier. The very best place to fill the padded lid is in between the piano and the preceding tier or in between the wall and the piano.

Grand pianos represent a substantial obstacle, they can be moved without damage by utilizing common sense and practicing the treatments listed above.

Leave a Reply

Your email address will not be published. Required fields are marked *